End Angle
- Each end has an angle which helps determine the curve shape. It can only be set if the Track is not joined at that end.
End Radius
- Each end has an radius which helps determine the curve shape. It can only be set if the Track is not joined at that end.
End Pt
- Each End Point has a position. It can only be set if the Track is not joined at that end.
Center
- Each End shows the center of the curve of the end segment - this is a read-only field. If the radius is zero, the field will show {0,0}.
Minimum Radius
- This is the approximate smallest radius along the curve based on curve fitting to the Cornu.
Maximum Rate of Curvature
- The maximum rate that the radius is changing over its length based on curve fitting. It gives an idea of the "sharpness" of the curve.
Total Winding Angle
- The number of degrees that the curve executes - this number will rise if there are loops in the curve.